Do You Remove Drip Edge Before Gutters

Current roof gutter without drip edge or flashing.

Do you remove drip edge before gutters.

Its main purpose is to eliminate the water from going behind the gutter. A furring edge is a strip of one by two wood you install on the vertical surface of the house just beneath the roof s edge. When it rains the water from the roof goes to the edge of the shingles and when the water backflows it hits the drip edge. Install drip edges on the eaves first.

Although it is not the intention drip edge flashing will also provide protection for the fascia board. If the gutter is lower than the bottom edge of the drip edge install flashing behind the drip edge and over the back edge of the gutter to remove the gap. This helps to extend the life of the wood. Drip edge is applied on the edge of the house roof to filter out all the water from the roof system.

It directs all the water away from the fascia and then into the gutter. The drip edge further diverts it into the gutter. One gutter contractor advocates installation of flashing. Because the drip edge directs the water directly down and into the gutters the back of the fascia is protected from excessive moisture.

If this is the. Water stains dirt debris and dripping water behind a gutter are usually the result of poorly installed or missing drip edge. Drip edges are usually available in the shape of t. Place the drip.

They are also known as d metal. Gutters in need of replacement roof not yet in need of replacement. Another says it should only be done when replacing the roof so as not to damage the siding or the roof with attempted installation. The only time you might not want to replace gutter flashing is when you don t want to remove decorative guttering that attaches with spikes or screws through the existing drip edge.

Most premade drip edge flashin.